37795-3-0119
Page 20
FiRepiT inSTallaTiOn (cOnT'D)
FINISHING
crushed Glass installation
Ensure the burner cover screens are still properly installed,
fully covering the LED openings. Place decorative crushed
glass evenly over the burner and screens (enough media to
cover approximately 7 sq. ft. on OL48TP, or 8 sq. ft. on OL60TP
models). (See page 6 for media requirements). Ensure coverage
is even and not thicker in places.
NOTICE:
Excessive amounts of crushed
glass placed over the burner, electrode,
or thermopile may cause various issues
including delayed lighting or sooting.
Some pieces of broken glass may be larger than others. It is
fine to use these pieces, but not over the burner or flame area.
See Figure 29.
Decorative glass droplets may be added as an
enhancement, but can not be used near or over the burner.
See
Figure 30.
Neither glass nor droplets may be placed over the
electrode. (See page 6 for media accessories and requirements).
COVER ENTIRE BURNER AND SCREENED
AREAS WITH CRUSHED GLASS
SPREAD CRUSHED GLASS AWAY
FROM
DO NOT COVER
THERMOCOUPLE AND
ELECTRODE
Figure 29
IF DESIRED GLASS DROPLETS
MAY BE ADDED IN AREA SHOWN - DO NOT USE DROPLETS
ON BURNER
Figure 30