eMotimo spectrum ST4, Инструкция по эксплуатации

Страница: 27 / 38

27
Copyright © 2018 eMotimo INC
Using an external intervalometer
Externally Triggering from the I/O port: In special cases where you want to use external timing
controlled by exposure ramping solution like the View, Ramper Pro, or DSLR dashboard here are
some quick setup tips.
a. Insert the i/o triggering cable to the side of the spectrum. This is the stereo port on the
right under the i/o icon. Watch out, don’t put this in the camera triggering port or it won’t
work.
b. The other end of the trigger cable can be a manual external intervalometer, or a bramper
solution like The View. If you are using the view, use their AUX2 port.
c. On your ST4, set up a timelapse shot and start it.
d. Pause the program by hitting the X button or the center of the onboard joystick. If you
need to jog back to the start, use the left DPAD or joystick to scrub to the beginning of your
shot.
e. The I/O port is now “looking for a signal telling the spectrum the camera’s shot is complete
to allow it to move the next position. Once received, the spectrum will advance to its next
position.
Manually triggering a shot for stop motion from the PS4 Dualshock
a. On your ST4, set up a timelapse shot and start it.
b. Pause the program by hitting the X button or the center of the onboard joystick. If you
need to jog back to the start, use the left DPAD or joystick to scrub to the beginning of your
shot.
c. By hitting the R1 button on the PS4 remote, the spectrum will send a shutter signal to your
camera through the camera triggering port, and then advance to the next position and wait.
d. Move Wallace or Grommit, or whatever other stop motion subject you are shooting.
e. When ready, hit the R1 button again.
f. Repeat.
g. The I/O port is now “looking for a signal telling the spectrum the camera’s shot is complete
to allow it to move the next position. Once received, the spectrum will advance to its next
position.
Reasons to externally trigger
• Want to manually advance a shot (stop-motion).
• Want to use a ramping solution and need to time motion.
• Want to synchronize multiple motion control rigs.
The i/o port is a triggering port AND a communications port for serial communication. We
allow users to configure the port to use three ways:
• Ext. Trigger, eMotimo API, or Dragonframe.
• Make sure have selected Ext.
• Trigger for the above modes.