eMotimo spectrum ST4, Инструкция по эксплуатации

Страница: 25 / 38

25
Copyright © 2018 eMotimo INC
8. Ramp (SMS TL and Video): Ramp controls how smooth your starts and stops in your final
footage are going to look. A low ramp means you are going to have an abrupt start and stop
and a high ramp means you will have a very smooth start and stop. The number you select for
your ramp in SMS TL is the number of frames in the final footage that show acceleration and
deceleration. If you have 50 frames of ramp, you will have 50 frames at the beginning of your
shot and 50 at the end of your shot where the footage shows acceleration and deceleration. If
you are shooting in Video mode, your ramp will be represented as duration in seconds. This
will be the time at the start and end of your shot that is ramped.
9. Lead in and Lead out (SMS TL only): Stationary lead-in/out is the number of stationary shots
at the beginning and end of your programmed move. For example, if you set “24 in 48 out”,
your program will fire your camera 24 shots at your set interval before any movement occurs.
The ST4 will fire your camera 48 shots at the end of the shot, after movement has finished. If
your final footage of your compiled shot is 24 FPS, then these “lead in/out” settings result in 1
second of stationary time at the start of your shot and 2 seconds of stationary time at the end
of your shot.
10. Add Frames (multi key-frames):
Watch video for more details here: https://vimeo.
com/185580976 . Here you can select how many additional key-frames you want to add to your
two-point move. Add one for a 3-point shot, two for a 4-point shot, and so on.
11. Select Axis Move Type: Here, by axis, you select between a 2-point move (Start/End) and
multi-key-frames (3-7 depending on what was selected for Add Frames on previous page) for
each axis. If you select Pan, for example, and set it to start/end, then that axis will only move
between the start point and end point. However, if you set Pan to multi-key-frame, the pan will
transition from the start-point through all the middle key-frames and to the end-point smoothly.
Here you can also change Focus Fz motion from curved to linear. As a result, your Fz will
move directly to each key-frame without arcing the motion between points.