emmeti ECO HYDRO KIT ITM-200 B, Инструкция по установке и эксплуатации

Страница: 75 / 80

75
GB
Fig. 2A
Fig. 2B
Fig. 2C
Fig. 2D
Fig. 2E
2
Upper screw
High
frontal panel
Frontal
screw
Upper screw
Cover
Upper cap
Vent valve
Gasket
Gasket
Insulated pipe 1
Insulated pipe 1
3/4”
Ball valve
Insulated pipe 2
3/4”
Ball valve
Gasket
Insulated
pipe 2
Vent
valve
Gasket
Circulator
Pipe union
Gasket
Circulator
insulation
Working safely
- Remove the power supply from the ITM 200 unit
and make sure that the water temperature and
pressure are such that the intervention can be
carried out.
Fig. 2A)
Remove the “HIGH FRONT PANEL” by unscrewing
the upper screw and pulling the panel upwards.
Fig. 2B)
Remove the “COVER” by unscrewing the 2 upper
screws and the 2 front screws.
Fig. 2C)
Remove the 2 upper caps of the 25 litre inertial
accumulation to install “TUBE 1” and then the
“CIRCULATOR” with “TUBE 2”. Use all components
as shown in the figure.
Make sure there are no leaks from the hydraulic
circuit.
Electrically connect the circulator to the electrical
panel following the diagram inside the electrical
panel. Insert the circulator power cable through
the input provided on the electrical panel.
Check the correct operation of the unit complete
with “P2 CIRCULATOR KIT”. Reassemble the pre-
viously removed aesthetic panels in reverse order.
Installation instruction "P2 Circulator Kit"