Connecting the DC Cables
DAMAGE FROM A REVERSE POLARITY CONNECTION
DC power connections to the SPG must be positive to positive and negative to negative.
A
reverse polarity connection
(connecting positive to negative) can cause permanent damage to the
SPG. Damage caused by a reverse polarity connection is not covered by the warranty.
Failure to follow these instructions can damage the unit and/or damage other equipment.
Make sure the SPG's ON/OFF switch is in the centre position.
SPG’s positive [
RED
] DC Cable to properly connected
positive terminal of the battery
.
SPG's Negative [
Black
] DC Cable to properly connected
Negative terminal of the battery
.
Do not install SPG near flammable materials like plywood, chemicals, gasoline, etc.
Always ensure you connect the SPG system to an earthed shockproof socket outlet.
Ensure proper Tools / connections for Solar Input to SPG and AC Output from SPG.
Please make sure the battery inter connections (Series Parallel in case of need) were done
Properly as per system voltage requirement.
Connect the Battery, Solar Panel and AC mains as per the instruction given in Pic Rear View.
Please make sure the switch in the front panel was in Centre position.
Connect Battery terminals with battery by ensuring correct polarity
(Wrong Polarity connection will lead to permanent failure of the product)
Connect PV Terminals with solar panel by ensuring correct polarity
(Wrong Polarity connection will lead to permanent failure of the product)
Connect the loads with SPG with Output Socket provided for AC Output, Kindly make sure the AC socket
used to draw AC power suits the existing AC socket and free from damage.
6
