TB-6584
Page 7 of 13
© 2016 DESCO INDUSTRIES, INC.
Employee Owned
3. Connect the ground cord, foot plate cable, Ethernet cable
(or RS-232 communication cable) and power adapter to
the SmartLog V5™.
4. Route all cables through the openings located at the
bottom and backside of the cover. Secure the cover to
the SmartLog with the included thumb screw. All cables
should exit the SmartLog as shown below.
5. Connect the ground cord’s ring terminal to a known
ground point. Connect the foot plate cable to the foot
plate. Verify that the Ethernet cable is connected to your
network (or use the serial port adapter to connect the
RS-232 cable to your PC).
6. Power the SmartLog V5™. The display will turn on and
the tester LEDs will blink then turn off. If the footwear
status LEDs continue to blink, inspect the foot plate cable
and verify that it is securely connected at both terminals.
Hardware Setup
If the SmartLog V5™ is located near a restroom, sink or
other water source, operators will need to be instructed to
thoroughly dry their hands before testing. Wet hands may
cause inaccurate test results and damage to the tester.
1. Use the included screws and anchors to secure the
mounting bracket to the desired location. The screws
may be used in any of the four holes shown below. Be
sure to locate the bracket where users can read the
display and use the tester.
Figure 4. Installing the SmartLog V5™ mounting bracket
2. Connect the SmartLog V5™ to the bracket. Use the
included thumbscrew to secure the SmartLog as shown
below.
Figure 5. Connecting the SmartLog V5™ to the bracket
Figure 7. Use the EMIT 50415 stand as a mounting
alternative
Figure 6. Routing the cables out of the SmartLog V5™
www.
.com
1.800.561.8187
