EMGA 859.715, Руководство пользователя

Страница: 16 / 37

`
16
HIGH LIMIT SET
Ɣ
LOW LIMIT is set to zero
Ɣ
The display will show “ LO” and the beeper will be off when the weight is less than the
High Limit.
Ɣ
Above the High Limit the display will show “ OK” and the beeper will be on.
Note :1) When you would like to use check-counting/percentage, sampling should be set
before you set HI/LO limit values
2) The low limit is set greater than the high limit. In this situation, the display will
show E5 and you are supposed to reset the values.
3) The weight must be greater than 20 scale divisions for the check-weighing to
operate.
4) To disable the Check-weighing function enter zero into both limits by pressing
the “ CHECK/
◀
” key to recall the current settings. Pressing “ UNIT/Clear” key
when the current limits are shown to clear the settings, then pressing the
“
TARE/Enter” key to store the zero values.
6.7 Hold function
When weighing an active thing, press “ HOLD” key to hold the display to read the value
easily and clearly.
Place the load on the scale and press “
HOLD” key. Both “hold” and the value will flicker for
about 2 seconds. Then “Hold” disappears and the display window will show the weighing
value.
Note : 1) When there is no load on the pan, hold function is unavailable.
2) Hold function is possible to operate only when the scale is stable with “ ”
859715-25-35 en ma 2012-07