U.L. Model No.: CF3300
10
Final Installation
4.
Attach the decorative straps to the upper ring using
the flat head screw and nut (provided in the
downrod kit), Figure 16.
UPPER DECORATIVE
DOWNROD SLEEVE
SETSCREW (4)
DECORATIVE
STRAP RING
CEILING
CANOPY
DOWNROD
FAN ASSEMBLY
STRAP SLOT
1.
Loose the setscrew on the upper decorative
downrod sleeve and gently slide it up toward the
ceiling canopy (Figure 15).
2.
Position the top of the decorative strap ring
approximately 1/4” below the knurled nuts on the
canopy cover. The strap ring must not make
contact with the knurled nuts to allow the fan to
freely pivot on the hanger ball. Align the support
strap ring so that the slots are in the same position
as the slots of the strap supports on the fan
assembly below (Figure 15).
3.
Tighten the four setscrews in the upper decorative
downrod sleeve to secure the decorative strap ring
and upper decorative downrod sleeve to the
downrod (Figure 15).
Figure 15
5.
Assemble the buckle onto the decorative strap
(Figure 17).
6.
Slide the strap back through the buckle as shown
in Figure 17.
7.
Position the buckle on the strap as desired.
NOTE: Do not over tighten the straps, the tension
should be snug but not over tight.
8.
Slide the other end of the decorative strap through
the fan assembly strap slot (Figure 17).
9.
Assemble the second decorative strap to the other
side of strap support on the fan assembly as
previously instructed.
NOTE: Be careful not to scratch the downrod
while moving the sleeve.
FAN MOTOR COVER (1 FOR
EACH FAN MOTOR ASSEMBLY)
FAN MOTOR
ASSEMBLY
THREADED NIPPLE
5.
Thread the fan motor cover onto the fan motor
assembly threaded nipple and rotate cover
clockwise to tighten securely. (Figure 14).
6.
Repeat fan motor cover instructions for second fan
motor assembly.
Figure 14
NUT
DECORATIVE
STRAP RING
CEILING
CANOPY
DOWNROD
FLAT HEAD
SCREW
UPPER DECORATIVE
DOWNROD SLEEVE
DECORATIVE
STRAP
Figure 16
