4
PACSystems™ RSTi
-EP EPSCPE100 Standalone CPU Quick Start Guide
GFK-3012E
Membrane Run/Stop Pushbutton
The Membrane Run/Stop push button is located at the
bottom right of the front panel (see Figure 1). Pressing
it briefly, will change the state of CPU from the state it
is in to the next state. It acts as a toggle switch, as
shown in the following state diagram:
The Run/Stop switch is
enabled by default; it
can be disabled in PME
Hardware
Configuration (HWC)
settings.
LED Indicators (LEDs)
Ethernet Status Indicators
For each port of LAN1 and LAN2, there are two LEDs (Yellow/Green) embedded in the
RJ-45 connectors. The green LED indicates an Ethernet connection has been
established on that port. The yellow LED indicates packet traffic on that port.
Module Status Indicators
As shown at right, there are three LEDs located
at the bottom right of the front panel (Figure 2),
just below the Membrane Push Button.
The following tables describe the behavior of
each module LED:
Figure 1: Start/Stop
Pushbutton
Figure 2: LED
Indicators
