24
PACSystems™ RSTi
-EP EPSCPE100 Standalone CPU Quick Start Guide
GFK-3012E
7.
Using the reverse procedure, install the new supercapacitor card onto its carrier
board. Check that the mounting holes are aligned properly before tightening
both the M2.5 screws. Recommended torque is= 3 in-lb (0.3 Nm).
8.
Reconnect the mating connectors.
9.
Verify the assembly has been restored as shown in Figure 14.
10.
Clean or blow away any contaminants that may have fallen into the enclosure.
11.
Mount the side panel cover and tighten the four M3 Screws. Recommended
torque is 5 in-lb (0.6 Nm).
12.
The unit is now ready for use.
13.
Mount the unit and reconnect power.
14.
After power-up, confirm that the repaired unit does not log a Failed battery
signal fault in the controller fault table.
