CAM216/16 IOM
Doc. Number: ECM-402-0116
January 2016, Rev. 1
31
Section 5: Detailed Setup and Options
Detailed Setup and Options
The first option is the solid-state reversing starter, which will allow a higher degree of
accuracy of control, and as such, a smaller degree of Dead band. The second option is
a Variable Frequency Controller, which is used for the highest degree of accuracy and
the smallest degree of Dead band. The DCM also has a setup for these optional motor
starter types and must be set up for them. For more information, please refer to the
Valve Automation Controlinc Quick Startup Guide.
5.8
ESD Command
This command is available with the device is in both Modulating and Block Modes. This
command overrides all other commands and forces the actuator to a pre-selected position,
CLOSE, OPEN, or STAY-PUT. These pre-selected positions are options that can be set on the
DCM. If the DCM has ESD set and the actuator is commanded into ESD, the actuator will not
respond to any other movement commands until the ESD command is removed.
NOTE:
“ESD on lost communication” feature is not available when using HART CAM16/216 since the
HART board maintains power even after it is cut off from the host and polling of the
actuator continues.
5.9
Input Output Channel Listing
Table 21.
Input Output Channel Table
Parameters
MPA
M2CP
320B
HQDCM33 TEC2000
TEC2 /
Model
500
EHO
Analog Input 1
N/A
Yes
Yes
Yes
Yes
Yes
Analog Input 2
N/A
Yes
N/A
Yes
Yes
Yes
Analog Output 1
N/A
Yes
Yes
Yes
Yes
Yes
Analog Output 2
N/A
N/A
N/A
N/A 1
Yes 2
Yes
Discrete Input 1
N/A
Yes
Yes
Yes
Yes
Yes
Discrete Input 2
N/A
Yes
Yes
Yes
Yes
Yes
Discrete Input 3
N/A
N/A
N/A
Yes
Yes
Yes
Discrete Input 4
N/A
N/A
N/A
Yes
Yes
Yes
Discrete Input 5
N/A
N/A
N/A
Yes
Yes
Yes
Discrete Input 6
N/A
N/A
N/A
Yes
Yes
Yes
Relay 1
N/A
Yes
N/A
Yes
Yes
Yes
Relay 2
N/A
Yes
N/A
Yes
Yes
Yes
Relay 3
N/A
N/A
N/A
Yes
Yes
Yes
Relay 4
N/A
N/A
N/A
Yes
Yes
Yes
Relay 5
N/A
Yes
N/A
Yes
Yes
Yes
NOTE:
- For HART CAM Card, Analog Output 2 is not applicable. The reason for this is, CAM Boards can
only be mounted on the Controlinc ACM. The Controlinc ACM supports only 2 Analog Inputs
and 1 Analog Output
- Unlike TEC2000, TEC2 has a separate ACM called TEC2 ACM and it supports 2 Analog Inputs
and 2 Analog Outputs as well
