22
C6.1.9/0219/E
2.16.3 Location of the "Hot Key" plug connection on the XCM25D controller
The "Hot Key" plug connection is located on the upper left corner of the XCM25D.
Figure 21: Location of "Hot Key" plug connection
2.16.4 How to program a "Hot Key" from the controller (upload)
▪
Program one controller with the front keypad.
▪
When the controller is on, insert the "Hot Key" and press the
UP
key; the
"uPL"
message
appears followed a by a flashing "
End
" label.
▪
Press the
SET
key and the "
End
" label will stop flashing.
▪
Turn the controller off, remove the "Hot Key" and then turn it on again.
NOTE: The "Err" message appears in case of a failed programming operation. In this case
push the key again if you want to restart the upload or remove the "Hot Key" to abort the
operation.
2.16.5 How to program a controller using an Emerson "Hot Key" (download)
▪
Turn the controller off.
▪
Insert a pre-programmed "Hot Key" into the 5-pin receptacle and turn the controller on.
▪
The parameter list of the hot key will be automatically downloaded into the controller memory.
The "
doL
" message will blink followed a by a flashing "
End
" label.
▪
After 10 seconds the controller will restart working with the new parameters.
▪
Remove the "Hot Key".
NOTE: The message "Err" is displayed in case of a failed programming operation. In this case
turn the unit off, then on again if you want to restart the download, or remove the "Hot Key"
to abort the operation.
Содержание Copeland Eazycool OLTE-82D-TFD
Страница 1: ...Application Guidelines Copeland Eazycool Large Outdoor Condensing Unit ...
Страница 5: ......
