14
ETL Model No.: CF955-3
Remote Control Procedures
(continued)
Setting Operating Frequency of Remote Control
Your remote control has code switches which must be
set in one of 32 possible code combinations (Figure
14). The five levers (numbered 1, 2, 3, 4, and 5) on
the switches are factory-set in the ON (up) position.
Change the switch settings as follows (Figure 16):
1.
Slide the five switch levers in the remote control to
your choice of ON (up) or down positions. Use a
ball-point pen or small screwdriver and slide the
levers firmly up or down.
2.
Restore electrical power to the ceiling fan at the
circuit breaker panel or fuse box.
3.
Within 1 minute of restoring electricity, push and
hold the remote control OFF button ( ) for 3 to 5
seconds to set the code in the receiver. The fan's
lights will blink several times to confirm the fan is
programmed.
NOTE: The ceiling fan receiver will not respond to
transmitter commands if the transmitter’s
frequency switch settings are changed without
reprogramming the receiver. Program the receiver
to the new frequency by repeating the “Setting
Operating Frequency of Remote Control” and
“High Speed Conditioning” instructions.
IMPORTANT: The following steps must be
completed immediately following the
frequency programming of the ceiling fan.
1.
Press the ( ) speed button until all 6 LED
indicators are lit. Let the fan operate on high
speed for 2 minutes without interruption.
2.
After 2 minutes, press the reverse ( ) button
and allow the fan to operate uninterupted for
2 minutes at high speed.
3.
High speed conditioning is now complete.
High Speed Conditioning
1.
To turn on or shut off the ceiling fan, press and
release the ( ) button.
2.
To set the desired fan speed, press the ( )
button to decrease the speed and the ( ) to
increase the speed. The LED display will light up
to indicate the new speed selected.
3.
If airflow is desired in the opposite direction, press
the ( ) button on the remote control. The fan
must be operating at any speed for the reverse
button to function. The blades will turn in the
opposite direction and reverse the airflow in
approximately 30 seconds.
4.
To turn the downlight on or off, press and release
the ( ) button.
Operating Your Ceiling Fan
Figure 16
