6
ETL Model No.: CF430
3. Ceiling Fan Assembly
(continued)
3.5
Place the ceiling cover over the downrod. Be sure both
the ceiling cover and the coupler cover are oriented
correctly (Figure 4).
CEILING
COVER
COUPLER
COVER
DOWNROD
Figure 4
HANGER
BALL
PIN
SETSCREW
DOWNROD
Figure 5
3.6
Reinstall the hanger ball (Figure 5) on the downrod as
follows. Route the motor leads through the downrod.
Position the pin through the two holes in the downrod
and align the ball so the pin is captured in the groove in
the top of the hanger ball. Pull the hanger ball up tight
against the pin and securely tighten the setscrew in the
hanger ball. A loose setscrew could create fan wobble.
3.7
The fan comes with blue, black and white leads that are
80-inches long. Before installing the fan, measure up
approximately 6 to 9-inches above top of hanger
ball/downrod assembly. Cut off excess leads and strip
back insulation 1/2-inch from end of leads.
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened. Failure
to verify that the pin and setscrew are properly
installed could result in the fan falling.
WARNING
!
BP7486 CF430 Highrise OM 12/13/13 10:35 AM Page 6
