18
ETL Model No.: CF430
7. Wall Control Procedures
(continued)
PROGRAMMING THE RECEIVER
OPERATING FREQUENCY & HIGH SPEED
CONDITIONING OF FAN CONTROL
7.24
Within 1 minute of restoring electricity to the ceiling fan,
push and hold the fan OFF button ( ) for 3 to 5
seconds to set the code in the receiver. The ceiling fan
lights (if installed) will blink to indicate the transmitted
has been paired with the receiver.
7.25
If programming is unsuccessful, retry the above
instructions after cycling the wall control ON/OFF switch
to restart the 1 minute programming time period.
USING YOUR CEILING FAN
Your wall control has full control of your fan and light.
NOTE: Prior to operation of the fan and light from
the wall control, set the fan speed to HIGH (....) and
turn the light ON ( ).
7.27
To set the desired fan speed, press one of the four
buttons (
.
,
..
,
...
,
....
) to operate your fan on from low to
high speeds (Figure 24).
7.28
To turn the light on and off, press and release the
LIGHT ( ) button.
7.29
Your fan is now wired to be turned on and off from the
fan switch.
7.26
If still unsuccessful, shut off the electricity at the fuse
box or breaker panel and change the wall control
frequency (step 7.3, page 15). After changing the
frequency settings, repeat instruction #1 (step 7.24) of
this section within one minute of restoring the electricity.
Fan installation must be completed, including the
installation of the fan blades, before testing the remote
control.
WARNING
!
OFF
ON
....
HIGH TO LOW
BUTTONS
ON/OFF SWITCH
O = OFF / — = ON
LIGHT BUTTON
FAN BUTTON
POWER
INDICATOR
LIGHT
Figure 24
BP7486 CF430 Highrise OM 12/13/13 10:35 AM Page 18
