16
ETL Model No.: CF430
7. Wall Control Procedures
(continued)
3-WAY INSTALLATION
(One fan controlled by two different wall controls)
(See Figures 22 and 23.) Requires purchase of
accessory SW406 wall control.
7.14
Disconnect electrical power to the branch circuit at the
circuit breaker or fuse box before attempting to install
the ceiling fan wall control into the outlet box.
7.15
At all wall box locations remove faceplates and screws
from existing controls. Pull controls out from wall boxes
and determine which wall box contains the “hot” lead
and which wall box contains the “load” wire. Also,
identify traveler wires which are common to both wall
boxes. Disconnect wires from existing controls only. Do
not attempt to disconnect any wires not already
connected to existing controls.
7.16
Before installing wall control, place wall control in “OFF”
mode by pushing “ON/OFF” switch to the “OFF”
position.
7.17
Install a wall control in the wall box containing the “hot”
wire first. Connect the black wire of the wall control to
the “hot” wire. Securely connect wires with wire
connectors supplied.
7.18
Connect one black wire of the wall control to both
remaining traveler wires in the wall box and secure with
wire connector supplied.
HOT
BLACK
SW406
FAN/LIGHT
WALL
CONTROL
TRAVELER
WIRE
BLK
BLK
LOAD
NEUTRAL
GROUND
RECEIVER LOCATED IN
THE CEILING COVER
BLACK
OFF
....
OFF
....
Figure 22
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse or circuit breaker box before
wiring. All wiring must be in accordance with National
and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
WARNING
!
SINGLE-POLE INSTALLATION (continued)
7.8
Before installing wall control, place wall control in “OFF”
mode by pushing “ON/OFF” switch to the “OFF”
position.
7.9
Connect one black wire of wall control to the “hot” wire.
Securely connect wires with wire connectors supplied
(Figure 21).
7.10
Connect one black wire of wall switch to the “load”
(black) wire in wall box. Securely connect wires with
wire connector supplied.
7.11
Screw wall control into wall box using the supplied
screws. Leave wall control in “OFF” mode until fan
installation is completed.
7.12
The wall control is supplied with a white, ivory, and
almond color switch covers. Choose the finish that best
suits your needs and snap the cover onto the wall
control (Figure 21).
7.13
Install decorator wall plate using the two screws
provided with wall plate. Leave wall control in “OFF”
mode until fan installation is completed (Figure 21).
SW406 FAN/LIGHT
WALL CONTROL
WALL BOX
BLACK
BLK
HOT
SWITCH COVER
DECORATIVE WALL PLATE
SCREWS (2)
NEUTRAL
WIRES
TO
120VA
C SOURCE
TO LOAD
G
R
OU
ND
OFF
ON
....
Figure 21
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
WARNING
!
BP7486 CF430 Highrise OM 12/13/13 10:35 AM Page 16
