7. Wall Control Procedures
7.1
Your Emerson Ceiling Fan/Light Control consists of wall
mounted transmitter and a receiver which is mounted
under the fan ceiling cover. The remote control is
designed to separately control your ceiling fan speed
and light intensity.
Code switches in the transmitter and receiver may be
set in 32 different positions. If your fan and light go on
and off without using your control, you may be getting
interference from other remote units such as garage
door openers, car alarms or security systems. To
remedy this situations, simply change the combination
code in your transmitter and receiver.
7.2
Preset Memory Feature:
Your Emerson receiver is
equipped with a preset memory feature. If the AC
supply to the receiver is powered through a wall switch,
when the switch is turned OFF, the control will
remember the light intensity and fan speed. When the
switch is turned back ON the light and fan will resume
operation as they were prior to the switch being turned
OFF.
14
ETL Model No.: CF430
INSTRUCTION TO THE USER (if device contains a digital device)
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment has been certified to comply with the limits for a class B computing device, pursuant to FCC
Rules. In order to maintain compliance with FCC regulations, shielded cables must be used with this
equipment. Operation with non-approved equipment or unshielded cables is likely to result in interference to
radio and TV reception. The user is cautioned that changes and modifications made to the equipment without
the approval of manufacturer could void the user’s authority to operate this equipment.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
BP7486 CF430 Highrise OM 12/13/13 10:35 AM Page 14
