20
| 2.0
installation
7.
Fasten inner members (pulled from the bracket assemblies in Step 2) to both sides of the UPS with eight m4 screws
provided in this kit. make sure that the retaining latch is near the rear of the UPS as shown in Figure 12.
M4 screw (8 pcs)
Retaining latch
Inner member
UPS
Figure 12: Installing inner members
8.
Use m4 screws to install ears on both sides of the UPS as shown in Figure 13.
M4 screw (8 pcs)
Ear (2 pcs)
UPS
Figure 13: Installing ears
9.
insert the UPS, with inner members attached, into the bracket assemblies by inserting the top and bottom edges of
the inner members into the top and bottom curved tracks of the front members. Slide the UPS into the rack as shown
in Figure 14.
NOTE:
The ends of the inner members are tapered to allow the rear of the UPS to be angled upward before insertion,
if space allows. Do not use the factory supplied rack handles to lift the UPS; their intended use is to slide the UPS in
and out of the rack.
NOTE:
The UPS should move smoothly into the bracket assemblies. if not, recheck the alignment of the front and rear
members from Steps 4 through 6.
