Emerson Process Management GmbH & Co. OHG
3-10
X-STREAM XEFD
Instruction Manual
HASXEDE-IM-EX
07/2017
3.6 Software
Editing
The editing mode enables changing param
-
eters. It is initiated by pressing
enter
.
If the selection is a
parameter list
, the current
entry is highlighted and may be changed by
up
and
down
.
If the selection is a
value
, the cursor is placed
over the last character. Use
up
and
down
to
change it.
Use
left
and
right
to select another char-
acter.
The type of available characters depends on
the position of the cursor:
•
It is not possible to select the minus sign or
decimal point as the last character.
•
It is not possible to select the decimal point
in integer values.
•
For decimal numbers, the decimal point can
be placed anywhere within certain limits.
There are two ways to exit the data entry
mode:
enter
: the entry is verified.If it is accepted,
it is saved and the new value dis-
played; if not, an error message is
displayed.
home
: Cancel: all settings and changes are
reset to their former values.
Component selection menu
Within the analyzer software, one can distin-
guish between analyzer related and compo
-
nent related menus: While the first contain
entries, relevant for the analyzer (e.g. time
setting), the second contain entries relevant
for a specific component (channel) only (e.g.
calibrating a channel).
For single channel analyzers, editing any
channel specific parameter will only effect
this one channel.
Different for multi-channel analyzers: Such in
-
struments require selecting a channel prior to
changing channel related parameters. When
a channel related menu entry is selected, au-
tomatically a SELECT COMPONENT menu
shows up, to select the component of interest,
or to cancel the current action.
Select the component / channel you want to
work with, and press
enter
.
This menu does not show on single-channel
units.
Within menu descriptions, the following points
out, that for multi-channel instruments a selec-
tion is required:
Select Component
Component:
Ch1
Press to return
Multi-channel unit:
In SELECT COMPONENT select the
channel to be ...
