Embassy ONEX, Инструкция по установке и обслуживанию

Страница: 49 / 80

49
12.10 - “Users’
menu”
When entering the “Users’ menu”, the
display, item “31” in figure 1, will start
blinking indicating that a change of
mode has taken place. To access the
“Users’ menu” (see also section 16 to
better understand the several menus):
press the button for 2
seconds until the display starts
blinking;
press and release the button
several times until the desired
parameter is displayed;
use the or keys, to
change the value of the selected
parameter.
press to save the parameter
change before going to the next
parameter.
When the last parameter has been
reached and the button
pressed, the display will stop blinking
indicating exit from the menu.
12 - USE
Adjustment of the curve angel as shown in
figures 40 and 41 when climatic adjustment is
active per section 12.3.
Adjustment of the “Minimum heating
temperature” as shown in figures 40 and 41 when
climatic adjustment is active per section 12.3.
Adjustment of the “Maximum heating
temperature” as shown in figures 40 and 41 when
climatic adjustment is active per section 12.3.
Adjustment of the parallel shift of the curve as
shown in figures 40 and 41 when climatic
adjustment is active per section 12.3.
Display of the calculated heating temperature
when climatic adjustment is active per section
12.3, or display of the temperature set by knob
“33” shown in figure 1.
Display of the domestic hot water temperature
when set by knob “32” shown in figure 1.
Display of last error code registered, section
12.12.2
Display of last lockout occurred, section 12.12.1
Setting range: 0,1 to 5,0
Setting range: see section 12.4.3
Setting range: see section 12.4.3
The adjustment is made by turning knob “33” shown
in figure 1. The selected curve can be shifted up or
down by
18 ° F (10 ° C) .
Temperature display only with a range between 68
° F (20 ° C) and 189 ° F (87 ° C) .
Temperature display only with a range between 104
° F (40 ° C) and 158 ° F (70 ° C) , see section 12.1
Error code display per section 12.12.2
Fault code per section 12.12.1
PARAMETER DESCRIPTION INFORMATION ON DISPLAY ITEM “2” of figure 42
NOTE: If no key is pressed for more
than 60 seconds, the control
automatically exists the “Users’
menu”. Any parameter change not
saved using the button, will
be lost.
The table below lists each “Users’
menu” parameter, what it affects and
its adjustment range.