P7 INSTALLATION
5. INSTALLATION
Correct disposal of this product
This symbol on the product, or in its packaging, indicates that this
product may not be treated as household waste. Instead, it should
be taken to the appropriate waste collection point for the recycling
of electrical and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could
other wise be caused by the inappropriate waste handling of this
product. For more detailed information about the recycling of this
product, please contact your local council, your household waste
disposal ser vice, or the shop where you purchased the product.
5.1 PIPING
1. A protective device is to be installed in the fixed wiring.
2. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensor y
or mental capabilities or lack of experience and knowledge if they have been given super vision or instruction
concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance shall not be made by children without super vision.
3. The appliance shall be installed in accordance with national wiring regulations means for disconnection must be
incorporated in the fixed wiring in accordance with the wiring rules. A disconnected incorporated in the fixed
wiring is to be provided.
4. The pump is to be supplied through a residual current device (RCD) or Ground Fault Circuit Interrupt (GFCI)
having a rated residual operation current not exceeding 30mA.
1. Install the pump as close to the pool as possible, preferably in a dr y, well ventilated area away from direct sun
light. Protect the pump from excessive moisture.
2. Place the pump as close to the water source as possible, so that the suction pipe is short, straight and direct to
reduce the friction loss. Don't install the pump at more than 10 ft (3 meters) of geometrical height from water
level.
3. Before installing the pump, make sure that the surface is solid, elevated, rigid and vibration free.
4. Secure the pump to the base with screws or bolts to limit the vibration and the stress on the pipe or the joints.
5. Leave enough space for gate valves in suction and discharge piping, if required.
6. Ensure there is enough clearance for pre-filter basket & Lid open and motor ventilation.
7. Connect the suction and discharge pipe to the outlet and inlet of the swimming pool.
8. Make sure that floor drainage is adequate to prevent flooding.
9. Make sure that the pump and piping are accessible for ser vicing.
