EMAK 101, Руководство оператора

Страница: 99 / 192

21 EN
5.4.5 Grass cutting
Adjust the position of the anti-
chipping wheels (1) whose
function is to reduce the risk
of tearing up sections of lawn,
which can occur when the
edge of the cutting deck
drags over irregular ground.
The four different heights of the wheels allows you to main-
tain a safe distance «A» between the cutting deck edge and
the ground.
To change the position, unscrew and remove the pin (1) then
reposition the wheel (2) in the upper and lower hole of the
wale corresponding to the wheel diameter.
This should always be performed
on both wheels, positioning them at the same height
WITH THE ENGINE OFF AND BLADES DISENGAGED.
WARNING!
Model 101
To start cutting:
– move the throttle to «FAST»;
– raise the cutting deck as high as possible;
– only use the blade ( 4.7), on grass lawns, do not use the
blades on stony ground or when the grass is very high.
– start moving forwards on the grass very slowly and with
utmost caution, as already described;
– regulate the cutting height and speed ( 4.8) considering
the conditions of the lawn (the height, density and dampness
of the grass).
When cutting on sloping ground, re -
duce your speed to ensure safe conditions ( 1.2 - 5.5).
Whatever the conditions, always reduce the speed if you notice
a drop in engine speed – if you travel too fast compared to the
amount of grass being cut, you will not be able to mow the grass
well.
Disengage the blades and raise the cutting deck as high as pos-
sible whenever you need to get past an obstacle.
5.4.6 Emptying the grass-catcher
This operation can only be done with the
blades disengaged, otherwise the engine stops.
Do not let the grass-catcher become too full as this may block
the collector channel.
WARNING!
NOTE
1
A
A = 30 mm
A = 10 mm
A = 20 mm
A = 0 mm
2
1