11
2.2.5.
Device numbering
If number encoding is programmed for 4 or 8 digits, i.e. when sequential encoding is not selected, press the key
to move to
the next item to enable modification of the correspondence between ID of each monitor or interphone with the numbering used to
call from the switchboard keyboard. If Sequential Encoding has been selected, the system skips directly to the next item.
If the number is made up entirely of ‘0’, this means that there is no association for the specified monitor or interphone (1 in the
example) and therefore no direct calls can be made.
To select the device to modify, use keys
and
. From position 1, press
to move to the next item in the program-
ming menu. Alternatively, enter the device number required directly:
Now press
In the event of discrepancies, the first line of the display shows the error:
Use the key
to skip all intermediate phases and go to the previous item in the programming menu
To modify the number value, press
:
To cancel the number, enter a single ‘0’:
and press
:
To insert a number, enter the digits:
To cancel the last digit, use key
:
Numbering comprises 4 or 8 digits which must all be entered or the procedure will not be completed:
To cancel press
. To confirm, press
. At this point, there is a check that the entered value does not already exist else-
where. If so, the user is notified:
In this case the system notifies that the code 7856 is already used for the device with ID 99.
Otherwise, acceptance of the command, as in all cases, is shown on the first line of the display:
To cancel all numbering, starting from where the current value is shown, press
:
On request for confirmation, press
:
and then
. Press
or
to cancel the procedure. If numbering reset is selected, the following is displa-
yed:
