36
GB
3 OPERATION
3.1 Vacuum cleaning
WARNING:
Check the vacuum cleaner and the power cord each time before use. A
damaged appliance must not be used. There is danger of injury.
ATTENTION:
Only use the vacuum cleaner with all filters intact, in dry condition and
correctly placed. Make sure that the openings of the vacuum cleaner are
not clogged or obstructed. Otherwise the vacuum cleaner might be dama-
ged.
NOTE:
Your vacuum cleaner is equipped with a safety switch to prevent overhea-
ting. It automatically cuts off the power supply if the motor overheats. If
this happens, switch off the vacuum cleaner and disconnect it from the
mains supply. Remove the cause of the overheating.
Wait for about 45 minutes. After it has cooled off, you
may use the vacuum cleaner again.
1. Attach the desired nozzle. See section 2.3, “Using
other nozzles (accessories)”.
2. Pull out the power cord until the yellow marking is
visible (Fig. 10/1).
WARNING:
If the red marking shows (Fig. 10/2) retract the cord by pressing the
retract button to rewind the cable (Fig. 11/2) back to the yellow mark.
Otherwise the power cord could be damaged. There
is danger of an electric shock.
3. Switch on the vacuum cleaner at the on/off switch
(Fig.11/1)
.