41
GB
4.4 Replacing the motor protection filter
1. Switch off the vacuum cleaner and remove the
dust filter bag as described in section 4.1, “Re-
placing the dust filter bag”, steps 1 through 4.
2. Remove the filter holder with motor protection
filter (Fig. 22/1 ). First, flip the filter holder for-
wards, then pull the filter up and out.
3. Remove the motor protection filter (Fig. 23/1)
from the filter holder (Fig. 23/2) over a dustbin.
4. Clean the filter holder.
5. If the new motor protection filter is too large, lay
the the old filter onto the new filter mat. Mark the
outline and cut the new filter down to size with a
pair of scissors.
6. Insert the new motor protection filter into the filter holder.
7. Insert the filter holder with the new filter into its
bracket from above and push it down until it
audibly locks into place.
8. Replace the dust filter bag and close the dust
compartment cover. The cover clicks into place
audibly.
4.5 Cleaning the housing
WARNING:
Always switch off the appliance and disconnect it from the mains supply
before cleaning it. See section 3.3, “Switching off and retracting power
cord”.
ATTENTION:
Do not use cleaning or scouring agents or alcohol, as these might damage
the appliance.
• Clean the outside of the housing using a slightly damp cloth only.
Fig. 20/1
