GB
73
Step 3. Adjusting the door spring tension
2. The door springs are set at the factory to the correct
tension for the outer door. If a wooden door panel is
fitted, you will have to adjust the door spring tension.
Rotate the adjusting screw to tighten or relax the steel
cable.
3. The door spring tension is correct when the door
remains horizontal in the fully opened position, but rises
to the closed position with slight finger pressure.
Step 4. Dishwasher installation steps
1. Fit the condensation strip under the work surface of the
cabinet. Please ensure the condensation strip is flush
with the edge of the work surface.
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher in position.
6. Level the dishwasher. The rear foot can be adjusted
from the front of the dishwasher by adjusting the screw
in the middle of the base of the dishwasher using a
cross-head screwdriver. To adjust the front feet, use a
flat-head screwdriver and turn the front feet until the
dishwasher is level.
7. Install the wooden door panel on the outer door of the
dishwasher. (Steps 7 to 10.)
8. Adjust the tension of the door springs by using an Allen
key; turn the key clockwise to tighten the left and right
door springs. Failure to do this could cause damage to
your dishwasher. (Step 11.)
9. The dishwasher must be secured in place. There are
two ways to do this:
A.
Normal work surface: Secure the dishwasher to the
work surface with the wood screws and retaining
strip.
B.
Marble or granite work top: Fix the sides with screws.
A
B
Step 5. Levelling the dishwasher
The dishwasher must be level to ensure correct dish racks
operation and wash performance.
10. Place a spirit level on the door and the rack guide inside
the dishwasher as shown to check that the appliance is
level.
11. Level the dishwasher by adjusting the three levelling
feet individually.
12. Once the dishwasher is level, make sure that it cannot
tip over.
B
2. Pin up the four long screws
1. Take away the four short screws
Remove the four short screws
Screw in the four long
screws