GB
88
Starting a wash cycle
1. Slide out the lower and upper basket, load the dishes and push them back. It is recommended that you load the lower
basket first, then the upper one.
2. Pour in the detergent.
3.
Insert the plug in the socket. For information on the electrical supply, refer to the last page “Product fiche”. Make sure
that the water supply is turned on at full pressure.
4. Close the door and press the Power button to turn on the machine.
5. Choose a program, the indicator light will turn on. Then close the door, the dishwasher will start its cycle.
Changing the program mid-cycle
A wash cycle can only be changed if it has been running for a short time, otherwise the detergent may have already been
released and the dishwasher may have already drained the wash water. If this is the case, the dishwasher needs to be reset
and the detergent dispenser must be refilled. To reset the dishwasher, follow the instructions below:
1. Open the door a little to stop the dishwasher; you can open the door completely after the spray arm has stopped
rotating.
2. Press the desired program button for more than three seconds and the dishwasher will enter standby mode.
3. You can change the program to whichever program you want.
Forget to add a dish?
A forgotten dish can be added any time before the detergent dispenser opens. If this is the case, follow the instructions
below:
4. Open the door a little to stop the washing.
5. After the spray arms stop rotating, you can open the door completely.
6. Add the forgotten dishes.
7. Close the door.
8. The dishwasher will start running again.
WARNING
It is dangerous to open the door mid-cycle, as hot steam may
scald you.
3 sec