GB
72
Built-in installation (for the integrated
model)
Step 1. Selecting the best location for the dishwasher
The installation position for the dishwasher should be near
the existing inlet and drain hoses and power cord.
The illustrations below show the cabinet dimensions and the
recommended installation position for the dishwasher.
1. The gap between the top of dishwasher and cabinet,
and between the edge of the outer door and the edge of
the cabinet could be less than 5 mm.
2. If the dishwasher is installed in a corner cabinet there
should be some space when the door is opened.
Dishwasher
Door of
dishwasher
Minimum
space of 50
mm
Cabinet
Space between
cabinet bottom
and floor
Electrical, drain and
water supply line
openings
90°
-
90°
820 mm
580 mm
80
100
600 mm (for 60 cm model)
450 mm (for 45 cm model)
NOTE
:
Depending on where your electrical outlet is, you may
need to cut a hole in the side of the nearest cabinet.
Step 2. Wooden door panel – dimensions and
installation
The wooden door panel should be installed according
to the installation drawings.
Semi-integrated model
Apply adhesive tape to the inside of the wooden panel
and to the outer door of dishwasher (see figure A). After
positioning the panel, fix the panel to the outer door
using the screws and bolts (see figure B).
Fully integrated model
Fit the handle to the wooden panel and insert the
handle supports into the slots in the outer door of the
dishwasher (see figure A). After positioning the panel,
fix the panel to the outer door using the screws and
bolts (see figure B).
Underneath existing work top
(When fitting beneath a work top)
In most modern fitted kitchens there is a single work
top under which cabinets and electrical appliances are
fitted. In this case remove the top of the dishwasher by
unscrewing the screws under the rear edge of the top
(a).
Attention
After removing the top from the dishwasher, refit the screws
under the rear edge (b).
The height will then be reduced to 815 mm, as specified by
international regulations (ISO) and the dishwasher will fit
perfectly under the kitchen work top.
a
a
b
b
B
2
.
Pin up the four long screws
1
.
Take away the four short screws
A
Magical paster
Magical paster
A
Double-
sided
adhesive
tape
Double-sided
adhesive tape
Remove the four short screws
Screw in the four long screws