ELTRA CSi/d, Руководство пользователя

Страница: 15 / 38

Installation
15
Proceed as follows to screw the CSi/d Autoloader to the analyzer:
1.

Place the CSi/d Autoloader tightly onto the analyzer.
2.

Switch to manual mode.
3.

Using the manual control button, switch through the individual steps of the
program until the gripper arm has reached the crucible position on the
analyzer (see Chapter 7.4: Gripper arm positions).
4.

Align the CSi/d Autoloader so that the gripper arm can place the crucible
midway on the crucible tray of the analyzer.
5.

Now align the height of the CSi/d Autoloader by screwing the three
pedestals in and out so that there is a small gap between the crucible and
the crucible tray of the analyzer. With the help of the supplied spirit level,
ensure that the CSi/d Autoloader is horizontal.
6.

Using the brackets, screw the CSi/d Autoloader to the analyzer. The CSi/d
Autoloader can be adjusted in a horizontal direction using the slotted holes
on the brackets (
1 ) (see Fig. 4: Aligning the CSi/d Autoloader).
7. Press the locking screw ( 2 ) against the brackets and screw it tight. This
prevents the position shifting if you need to disconnect the CSi/d Autoloader
from the analyzer (see Fig. 4: Aligning the CSi/d Autoloader).
The Autoloader has now been connected to the analyzer.
4.6 Individual step cycles
If the CSi/d Autoloader is in manual mode, it is possible to switch through the individual steps of
the device using the manual control button; the CSi/d Autoloader then follows the step
sequence for the analysis mode.
The step sequence follows the pattern below:
1. The crucible chain conveys the first crucible to the chain crucible position (see Chapter 7.4:
gripper arm positions).
2. The gripper fingers move to the analyzer crucible position (see Chapter 7.4: gripper arm
positions).
3. The gripper fingers move to the disposal crucible position (see Chapter 7.4: gripper arm
positions).
Pressing the manual control button again starts the next cycle. We recommend performing
several cycles in manual mode to ensure that the mechanical settings are correct. If not, they
must be adjusted again.