ELTRA CS-800, Руководство по эксплуатации

Страница: 21 / 28

Operating the machine
21
4 The beam of the horizontal laser cannot be detected. Defective laser
or detector, crucibles don´t move due to blockage, defective motor
etc.
5 The furnace is not opened for the loader to place a crucible on to the
pedestal. Error in the piston control or piston sensor.
6 The fingers didn´t take the crucible. The crucible blocks in its tray, no
compressed air, faulty laser or sensor etc.
7 The loader received the command for loading but the furnace is not
open, or the piston came down with big delay.
8 One dispenser empty
9 One dispenser empty.
∞ Infinitive number of beeps in manual mode. Piston sensor
disadjusted(low end of furnace cylinder).
1.20 Final installation after adjusting
Install the plate (18) , after you made sure that the loader is properly adjusted and
in full functional condition. (See figure arm installation)
1.21 Maintenance
The loader is maintenance free. It is only advisable when there are no crucibles on
the loader, from time to time to blow away with compressed air any possible dust or
grains from the platform to make it free of any dust and particles.
1.22 Analysis mode
To change over from this adjusting software to the analysis mode of the loader’s
software, do this:
1.
Switch off the power by setting the analyser’s mains power switch to position
0 (zero).
2. Now the loader is in analysis mode and not in single step mode which is
described before.
3. A couple of seconds later switch on to position 1. Don’t press this time the
adjust button.
4. Restore the oxygen supply to the analyser.
5. Set the power switch to position 2.
6. Connect the balance and the PC to the analyser. See operation manual
electrical connections.