ELTRA CS-800, Руководство по эксплуатации

Страница: 18 / 28

Operating the machine
18
so that the beam will be in the middle of the sensor (7). In case of proper
adjustment the beeper will stop beeping.
The adjustment is made by loosing the screws (8) and by turning and moving the
laser (6) until the beeping stops. If necessary, pull up or press down the blade (9)
for vertical adjustment.
NOTICE
It is very essential to adjust the laser for the whole beam to reach the detector. If
you see a part of the beam hitting the aluminium detector housing around the
detector’s hole, readjust until you don’t see any laser radiation on the aluminium
housing.
1.12 Single step cycles
• Place about 10 crucibles into the trays of the chain starting from the left front
tray (1) continuing to the left. (Crucibles 2, 3, 4 etc), see figure loader steps.
• Press the adjust button (5) see image pneumatic connections again for only
approx. one second. This will cause the arm to move to the home position
(vertical laser) and to return back and stay at the parking position.
From now on, after each short pressing of the adjust button, the loader will make
one single step, following the sequence of the steps in analysis mode. The single
step mode gives time for mechanical adjustments.
The sequence of the steps that follow now after each short pressing of the adjust
button (5) of figure pneumatic connections is as follows:
1.
The crucibles move so that the first crucible (1) stops at the crucible pick-up
position.
2. The fingers move first to the home position and then to the crucible pick-up
point.
3. The fingers move to the parking position.
4. The fingers (6) move to the position over the pedestal (8), see figure arm
installation.
1.13 Finger position over the pedestal
Now the mechanical adjustment of the position of the fingers (6) can be made.
For better orientation place a crucible (7) on to the pedestal (8). To move the
fingers (6) to the left and to the right, slightly loose the screws (9).The adjustment
of the finger (6) to the direction back and for is done with the screws (1). Take care
to keep the height of the arm (3) as advised before, i.e. about 1 mm underneath to
the wing nut (4).
Fingers down. Now you can adjust the fingers position even more accurately.
1.14 Finger Up/Down speed
The downwards speed of the fingers can be adjusted by the left hand adjustable
restrictor (7) see image pneumatic connections. The upwards speed of the fingers
can be adjusted with the restrictor (8). After adjusting, fix the knurled nuts.
1.
Fingers close and take the crucible. If the adjustment of the fingers (6)
position is coaxial to the pedestal (8) resp. to the crucible (7), the crucible will
not move in horizontal direction when the fingers close.
The closing speed of the fingers can be adjusted with the adjustable restrictor (9)
see image pneumatic connections.
2.
Fingers up.
3. Fingers turn to the disposal position.
4. The fingers open and the crucible is dropped.