86500019
Bedienungsanleitung Operating Instructions
ELTC-14
Autor
Peter Schmidt
Revision 8
01.06.2018
7 von/of 12
P01 ..Actual sensor temp. °C (disp.only)
P10 ..Control Setpoint
Affects relay 1, range P13...P14, [5°C]
P11 ..Switching hysteresis of P10 range 2..10K [2K]
P12 ..Min. Relay Idle Time (Relay K1)
0..30.0 Min., [0.0 Min, (Resolution 0,1 min.]
P13
Highest adjustable Control Setpoint
Range P14...+390°C [+390°C]
P14 ..Lowest adjustable Control Setpoint
Range -50°C...P13. [0°C]
P20 ..Sensor/probe Type
0 = Pt100, 3-wire, °C (Resolution 1K)
[1] = Pt100, 2-wire, °C (Resolution 1K) 2 = Pt100, 3-wire, °F (Resolution 2°F) 3 = Pt100, 2-wire, °F (Resolution
2°F)
P21 ..Sensor Correction -30...+10K, [0]
P30 ..High Temp. Alarm Threshold
P31...400°C, [400°C]
P31 ..Low Temp. Alarm Threshold
-60...P30, [-60°C]
P32 ..Alarm Delay while Operation
0...99 min., [0.0 Min., Resolution 0,1 Min.]
P33 ..Alarm Delay while Power-on
0...500 min., [0 min.]
P34 ..Alarm Relay Mode (Relay K1 and K2)
0 = Relay K2 ON at sensor fault
Power relay K1 OFF at sensor fault
[1] = Relay K2 OFF at sensor fault Power relay K1 OFF at sensor fault
2 = Relay K2 works as releasing relay Power relay K1 OFF at sensor fault
3 = Relay K2 ON at sensor fault Power relay K1 ON at sensor fault
4 = Relay K2 OFF at sensor fault Power relay K1 ON at sensor fault
5 = Relay K2 works as releasing relay Power relay K1 ON at sensor fault
IMPORTANT NOTE :
P34=3, P34=4 and P34=5
Is only for frost protection applications and use of self-regulating heating cables permitted.
Werte in [..] sind Werkseinstellungen
Values in [..] are factory settings
