WEP-3ax, WEP-3ax-Z. User manual
44
•
•
•
•
•
•
•
•
•
•
•
•
•
•
To enable access to the device via Telnet, check the box next to "Telnet";
To enable access to the device via SSH, check the box next to "SSH";
To enable access to the device via NETCONF, check the box next to "NETCONF";
WEP-3ax software allows monitoring status of the device and it's sensors via SNMP. In the SNMP submenu,
you can configure settings of SNMP agent. The device supports SNMPv1 and SNMPv2 protocol version.
To change the parameters of the access point SNMP agent, it is necessary to check the "SNMP" checkbox and
click on the "SNMP" link, a list of parameters available for editing will appear:
roCommunity
–
password for parameter reading (common:
public
);
rwCommunity
–
password for parameter writing (common:
private
);
TrapSink
–
IP address or domain name of SNMPv1-trap message recipient in HOST [COMMUNITY
[PORT]] format;
Trap2Sink
– IP address or domain name of SNMPv2-trap message recipient in HOST [COMMUNITY
[PORT]] format;
InformSink
– IP address or domain name of Inform message recipient in HOST [COMMUNITY [PORT]]
format;
Sys Name –
device name;
Sys Contact
–
device vendor contact information;
Sys Location
–
device location information;
Trap Community –
a password which is contained in traps (by default: trap).
The list of objects which are supported for reading and configuration via SNMP is given below:
eltexLtd.1.127.1 – monitoring access point parameters and connected client devices;
eltexLtd.1.127.3 – access point management (reboot).
where eltexLtd – 1.3.6.1.4.1.35265 is Eltex Enterprise ID.
To apply a new configuration and save setting to non-volatile memory, click "Apply". Click "Cancel" to discard
the changes.
Note that the ports for the HTTP and HTTPS protocols should not have the same value.
