WEP-3ax, WEP-3ax-Z. User manual
39
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
VLAN ID
– VLAN number from which the tag will be removed when transmitting Wi-Fi traffic to clients
connected to this VAP. When traffic flows in the opposite direction, untagged traffic from clients will be
tagged with VLAN ID (when VLAN Trunk mode is disabled);
SSID
– virtual wireless network name;
Broadcast SSID
– when checked, SSID broadcasting is on, otherwise it is disabled;
Band Steer
– when this flag is checked, the client's priority connection to the 5 GHz network is active. For
this function to work, you need to create a VAP with the same SSID on each radio interface, and activate
the "Band Steer" option on them;
VLAN Trunk
– when the flag is set, tagged traffic is transmitted to the subscriber;
General Mode
– when the flag is set, transmission of untagged traffic jointly with tagged traffic is
allowed (available when Trunk VLAN mode is enabled);
General VLAN ID
– a tag will be removed from the specified VLAN ID and the traffic of this VLAN will
pass to the client without a tag. When traffic passes in the opposite direction, untagged traffic will be
tagged with General VLAN ID;
Station Isolation
– when checked, traffic isolation between clients in the same VAP is enabled.
Priority
– select prioritization means. Defines the field on the basis of which the traffic transmitted to the
radio interface will be distributed in WMM queues:
DSCP –
will analyze the priority from the DSCP field of the IP packet header;
802.1p –
will analyze the priority from the CoS (Class of Service) field of the tagged packets.
Minimal Signal –
when the flag is checked, the function of disabling the client Wi-Fi equipment at low
signal level (Minimal Signal) is enabled
.
The following parameters must be configured for the
functionality to operate:
Minimal Signal Level
– signal level in dBm below which the client equipment is disconnected from
the virtual network;
Roaming Signal Level –
roaming sensitivity level in dBm, below which the client equipment is
switched to another access point. The parameter must be lower than the
Minimal Signal:
If
Minimal Signal
= -75 dBm, then the
Roaming Signal Level
must be equal or higher than -70 dBm.
Minimal Signal Timeout –
the period of time after which the decision is made to disconnect the
client equipment from the virtual network.
Security Mode
– wireless access security mode:
Off
– do not use encryption for data transfer. The access point is available for any subscriber to
connect;
WPA, WPA2, WPA/WPA2, WPA3 –
encryption methods, if you select one of the methods, the
following setting will be available:
WPA Key –
key/password required to connect to the virtual access point. The length of the
key makes from 8 to 63 characters;
WPA-Enterprise, WPA2-Enterprise, WPA/WPA2-Enterprise –
wireless channel encryption mode, in
which the client is authorized on the centralized RADIUS server. To configure this security mode,
you must specify the parameters of the RADIUS server. If you select one of the encryption modes,
the following setting will be available:
