____________________________________________________________________________________
____________________________________________________________________________________
66
VoIP subscriber gateways
ringbacktone_time_rule: 1000,4000
congestiontone_freq: 425,600
congestiontone_time_rule: 100,100,100,100
where
dialtone_freq
– frequencies of ‘
Station response
’
signal, Hz (up to two frequencies, frequencies are
separated by comma ‘,’);
dialtone_time_rule
– duration time intervals and signal pause with assigned frequency, in milliseconds
(signal and pause durations are specified for each frequency, the time intervals are separated by comma ‘,’).
Frequencies and time intervals for other signals are specified analogically:
busytone
– ‘busy’ signal;
ringbacktone
– ‘Ring back tone’ (RBT) signal;
congestiontone
– signal when there is no registration and ‘Outbound on busy’ mode of SIP profile is
disabled.
Value limit:
frequency range: 0 – 4000 Hz
time interval range: 0 – 65535 ms
To reset tone settings (restore default tones) to the factory default settings, click
‘Restore’
button
.
To save changes into the device operative memory, click
‘Save
changes’
button. To record settings into
non-volatile memory, click
‘Apply’
button.
3.1.4.5
‘
Hunt groups
’
submenu
Use the menu to run call groups (hunt groups).
Click ‘
Go to the page Hunt groups status
’
button to switch to the
‘Status/Telephony’
submenu (section
4.2.8
)
, where monitoring statistic of customer unit status, hunt groups and series selection groups are available.