Safety
3
Page 20 of 97
Operating Instructions
enCore FC1
Safety and warning instructions
The following safety and warning instructions must be observed
unconditionally:
•
Any individual appointed to perform work on or with the FC1
must read and understand these Operating Instructions
before beginning work. This also applies if the individual
concerned has already worked with such a device or a similar
one, or was instructed by the manufacturer.
•
In order to avoid risks and to ensure that the FC1 performs in
an optimal manner, no changes or modifications that were not
expressly authorized by the manufacturer may be performed
on the device.
•
The FC1 must not be exposed to temperatures below −25°C
or above +60°C during storage.
•
A temperature that is between −10°C and +55°C must be en-
sured while the FC1 is being operated.
•
The power supply in FC1 is over a 24 V DC, and this supply
must be protected externally using a 1A time-delay fuse.
•
The grounding system is connected to the power supply
socket PE for potential equalization.
•
The threshold values listed in the certificates of conformity
(e.g. EC type examination certificate ATEX) for the boards to
be connected to the device must be observed.
The threshold values that are listed in the certificate of conformity
for the applicable authorization must be observed while using the
device within the scope of legal metrology e.g. of EC type
examination certificate (MID).
For a description of the process boards
(p. 32).