15
Setting the parameters
Cala KNX M-T push button
• Version: 13.09.2019 • Technical changes and errors excepted.
Push button as blind, shutter, awning or window control
Specify the push button function and the control mode.
* For additional setting details, see
"Control modes for drive control" on page 17
Push button as dimmer
If the push button should be used as a dimmer, select the function "Dimmer" and de-
fine the push button function, time interval (switching/dimming) and if required, the re-
peat interval for extended pressing of the push button.
Use additional function for button held
down
Yes
Time between tap and hold (0.1 sec)
0 ... 50; 10
Command when pressing the button
Do not send message
Command when releasing before time
expires
• Switch
• Do not send message
Command when pressing the button
• 0 Send
• 1 Send
• Switch
• Do not send message
Command when releasing the button
• 0 Send
• 1 Send
• Switch
• Do not send message
Send value
• If there is a change
• on change to 1
• on change to 0
• on change and periodically
• on change to 1 and periodically
• on change to 0 and periodically
Transmission cycle (if cyclically sent)
5 s • 10 s • ... • 2 h
Function
Blind / shutters / awning / window
Command (button function)
Up • Down
Up • Down • Up/Down
Retract • Extend •
Retract/Extend
Open • Close • Open/
Close
(Blind)
(Shutters)
(Awning)
(Window)
Control mode*
• Standard
• Standard inverted
• Comfort mode
• Dead man switch
Function
Dimmer
