7
Operating the display
Solexa II Control
• from software version weather station 1.3, display 2.1 • Version: 11.05.2017
Technical changes and errors excepted.
3 – Time, day of the week
The time can be displayed in 12- or 24-hour mode. Further information on setting the
clock can be found in the
Setting the time
chapter in the manual.
4 – Settings menus
Tap to access the automatic settings or
hold down for 3 seconds to access the default settings.
The automatic settings are described in the
Automatic
chapter in the manual.
The default settings are described in the
Default setting
chapter in the manual.
5 – Room temperature and weather data
In this area, the indoor temperature value is displayed and, if a weather station is being
used, the outdoor/weather data also. In this case, tap on the area with the values to
switch between the "Temperature" display and the "Brightness/Wind" display.
Temperature display:
• Current outdoor temperature
(only if a weather station is being used)
• Current indoor temperature
Brightness/wind display
(only if a weather station is being used):
• Current brightness (light intensity)
• Current wind speed
Further information on the values for brightness and wind is in the manual, chapter
6 – Time reception (weather station)
If the radio symbol is displayed in the start screen, the controller has, within the last 5
minutes, received the actual time from the GPS receiver integrated into the weather
station.
If no radio symbol is displayed, then the time has not been received for over 5 minutes.
The controller's internal clock continues to run.
7 – Active output functions
The right-hand edge of the display indicates the selected output functions, i.e. auto-
matic mode status. There is a more precise description in the
symbols (automatic mode status)
, page 8 chapter.
