Description of the menu options
ELSA LANCOM DSL/10 Office
R27
Below is a detailed description of the meaning of each field:
PPP-list
The router needs the device names contained in the PPP list in order to determine the
security procedure settings suitable for the connection and to determine the
PPP parameters. It contains a maximum of 16 entries and is structured as follows:
Not all parameters can be reached via the telnet configuration. Use
ELSA LANconfig
so
far as possible.
Below is a detailed description of the meaning of each field:
Device-name
In the
Device Name
column, you can enter an original remote station name,
which you must then assign to the relevant remote station via the
Name
option
in the
Setup
menu.
SH-time
In this column, you can define appropriate connection time-outs (in seconds) for
the DSL connection.
If no data is being transmitted when this time expires, the connection on this
channel is released (default: 20).
AC-name
Name of desired access concentrator. If nothing is input here the
LANCOM
will
accept every AC with an appropriate service.
Service name
Name of desired service. If nothing is input the
LANCOM
will accept every
service offered.
Device-
name
Auth.
Key
Tim
e
Try
Conf
Fail
Term
Username
AACHEN
CHAP
*******
0
5
10
5
2
ELSA
Device-name
In the Device-name column, you can enter the name with which the remote station
logs onto the router
.
Entries are not case-sensitive!
Auth.
In this column, you can enter the security procedure to be used for verification of the
remote station. Default: PAP
none
The router does not negotiate authentication with the remote station
when establishing a connection. However, the remote station can
itself require authentication from the router. This is the case when
dialing up a connection to an ISP, for example.
PAP
The remote station is checked as per the Password Authentication
Protocol.
CHAP
The remote station is checked as per the Challenge Handshake
Authentication Protocol.
Key
A password may be entered in this column. Its presence is indicated by the symbol *
and it is used to check the remote station. It may consist of 95 characters (7-bit ASCII,
including spaces). Default: None
The
set ?
command shows a list of the allowable characters.
Time
In this column, you can enter the period of time between two remote station
verifications specified in minutes. The CHAP protocol must be set here.
Default: 0
Содержание Lancom DSL/10 Office
