Chapter 4
Configuration
MAN_105G_1.5
Page
42
Update Times
To change the
update times of
output
mappings,
select the
Update Times
option. Any
I/O registers
that have
already been
mapped to
remote outputs
will
automatically
be listed. The default update time is 10 minutes.
Changing Multiple Settings
You can change the Comms Fail Times or Update Times of several I/O points simultaneously
by using the <Shift> Select feature. For example, if you want to change all times to 1 minute,
you could change each individually, or you could “block” all entries using the “Shift” Select
feature and select “Edit”. You only need to enter the change once to change all of the inputs
selected. This feature is also available with the other configurable parameters.
4.3.3
Don’t Send if in Comm Fail
You can configure a special “Don’t Send if in Comms Fail” mapping. If this is configured for
a particular remote module, the 105G will not transmit output messages to this remote
address, if there is a communications failure status on any input or output configured for the
same remote address. Output messages will re-start when a message is received from the
remote module. The use of this option can prevent the radio channel becoming congested if
there are many outputs at that module.
