www.elpro.com.au
245U-E Wireless Ethernet Modem User Manual
3
Rev Version 2.24
NOTE Any changes or modifications not expressly approved by ELPRO could void the user’s
authority to operate this equipment.
This device should only be connected to PCs that are covered by either FCC DoC or are FCC certified.
Safety Notices
Exposure to RF energy is an important safety consideration. The FCC has adopted a safety standard for
human exposure to radio frequency electromagnetic energy emitted by FCC regulated equipment, as a
result of its actions in Docket 93-62 and OET Bulletin 65 Edition 97-01.
UL Notice
1. The Wireless Ethernet module is to be installed by trained personnel or licensed electricians only, and
installation must be carried out in accordance with the instructions listed in the Installation Guide and
applicable local regulatory codes.
2. The units are intended for Restricted Access Locations.
3. The Wireless Ethernet module is intended to be installed in a final enclosure, rated IP54, before use
outdoors.
4. The Equipment shall be powered using an external Listed Power Supply with LPS outputs, or a Class 2
Power Supply.
5. The Wireless Ethernet module must be properly grounded for surge protection before use.
6. If installed in a hazardous environment, coaxial cable shall be installed in a metallic conduit.
GNU Free Documentation License:
Copyright (C) 2009 Elpro.
ELPRO is using a part of Free Software code under the GNU General Public License in operating the 245U-E
product. This General Public License applies to most of the Free Software Foundation’s code and to any
other program whose authors commit by using it. The Free Software is copyrighted by Free Software
Foundation, Inc., and the program is licensed “As is” without warranty of any kind. Users are free to contact
Elpro at the email address [email protected] for instructions on how to obtain the source code used in
the 245U-E.
A copy of the license is included in “Appendix F - GNU FREE DOCUMENT LICENSE.”
Important Notice
ELPRO products are designed to be used in industrial environments by experienced industrial engineering
personnel with adequate knowledge of safety design considerations.
ELPRO radio products are used on unprotected license-free radio bands with radio noise and interference.
The products are designed to operate in the presence of noise and interference. However, in an extreme
cases radio noise and interference could cause product operation delays or operation failure. As with
all industrial electronic products, ELPRO products can fail in a variety of modes due to misuse, age, or
malfunction. We recommend that users and designers design systems using design techniques intended
to prevent personal injury or damage during product operation, and provide failure tolerant systems
to prevent personal injury or damage in the event of product failure. Designers must warn users of the