Elli ID. Charger, Руководство пользователя

Страница: 28 / 204

26
ID. Charger
EN
Install wallbo
x
b. Connect Neutral (N) wire of the power supply cable to the N feed-through
terminal, located next to the kWh meter.
c. Connect PE wire of the power supply cable to the first available slot
of the PE feed-through terminal, located next to the kWh meter.
B. ID. Charger and ID. Charger Connect without kWh meter
a. Connect L1 (and L2 and L3 - for 3-phase version) wire(s) of the power supply cable
to L1, L2, L3 slots of the feed-through terminals.
b. Connect Neutral (N) wire of the power supply cable to the N feed-through
terminal.
c. Connect PE wire of the power supply cable to the first available slot
of the PE feed-through terminal.
Color coding for power supply cable
Wires L1 L2 L3 N PE
Color
Brown Black Grey Blue Green/Yellow
NOTE: If the wallbox is not equipped with feed-through terminals or a kWh meter,
strip the individual wires to 15 mm (1-phase wallbox) or 10 mm (3-phase wallbox).
Afterwards, connect the supply cable wires directly to the connection terminals on
the lower central part of the power board according to the stated color coding.
2. Optionally, install and connect the CT coil cable.
a. Strip the outer insulation of the cable to a length of 50 mm,
then strip the individual wires to 7 mm.
b. Connect the signal wires.
CAUTION
Connecting the signal wires of the CT-coils incorrectly may result in improper installation,
which can cause the wallbox to exceed the configured maximum charging current.
— Make sure that the signal wires of the CT-coils are connected to the middle and right pins on
the power board connector. The left pin is reserved only for shield connection of such wires.
Insert the CT coil cable into the PCB connectors (MCVR 1.5/3-ST-3.81)
and secure the wires using a screwdriver.
c. Connect the PCB connectors to the power board.