Elkron IR200, Быстрый старт

Страница: 1 / 12

1/12
The PIR picks up movements within an assigned area and signals the Control Panel to activate the
alarm if an intruder crosses its’ path of detection.
The PIR consists of a two-part design made up of a cover and a base. The cover contains all the
electronics and optics and the base provides a means of fixing. The base has knockouts to allow
mounting on either a flat surface or in a corner situation with fixing screws and plugs provided.
Provision for a tamper switch that will be activated when the cover is detached from the base prevents
unauthorized access and removal from the mounting surface. The PIR can also alert you to signal
communication problems and low battery situations.
The PIR is designed to give a typical detection range of 12 meters when mounted at 2 meters above
ground.
IDENTIFYING THE PARTS
Remove the cover by loosening the button fixing screw, the inside of the PIR will revealed as shown.
Learn/Test Button
This button is used for testing the radio performance and for
learning purpose.
Tamper Switch
The Tamper switch protects the enclosure from being opened.
Test/Normal Mode Jumper Switch (JP1)
It is a 3-pin jumper switch
If the jumper link is in inserted between the left 2 pins, the
PIR is in Test mode.
If the jumper link is inserted between the right 2 pins, the PIR is in Normal operation mode.
GB
PIR MOTION DETECTOR (IR200)
DETECTEUR DE MOUVEMENT PIR (IR200)
PIR BEWEGUNGSSENSOR (IR200)
DS80IR9B-001A
LBT80624