22
ELR600RT/10-15-20
5. WALL INSTALLATION
Set the control unit to “Walk Test” mode (see the dedicated instruction manual).
While keeping the RX barrier in the desired position, press the TEST button on the transmitter to check
that it is within radio range of the control unit.
Once the correct position is confirmed, install the RX barrier and then the TX barrier.
Fix both barriers to the wall through the holes in the standard caps and the transmitter holders.
When installation and alignment are completed, close the covers with their screws.
Note: The barriers should be installed with the transmitter holder at the top
Make sure there are no Tamper signals on the control unit.
Set the control unit to “Walk Test” mode and obstruct the individual beams to check that the line-open
(alarm) signal arrives.
Exit “Walk Test”.
6. USING THE OPTIONAL ROTATION KIT
To perform this type of installation, purchase the separate kit code
80SP5G00113
.
Insert the rotating spacers included in the KIT in the transmitter holder bases of the RX and TX barriers.
Undo the standard tap cover screws on the RX and TX barriers and remove the covers.
Remove the standard caps.
