6
DS80MM1L-001
ENGLISH
DC600S - DC600S/BR is a magnetic contact/shock or piezoelectric vibration detector designed to generate alarms upon
opening of the door or window controlled or in the event of shocks or vibrations of the surface on which it is applied. The control
unit connected to this device will generate a single type of alarm in case of opening or detection of shocks or vibrations.
The device consists of a cover and a base. The cover contains all the electronic components, while the base is used for
installing the device. A tamper switch inside provides protection from unauthorised attempts to open or remove the device.
Part identification
1. LED Indicator/Learning/Test Button
Press the test button to transmit learning data to the control unit or to start a 3-minute test session
.
2. Cover fixing screw
3. Wall-mounting hole arrangement
4. Tamper switch
5. Battery insulation
6. Jumper for selecting detection type (JP3)
7. Jumper for selecting detection sensitivity (JP4, JP5)
8. Jumper for selecting magnet use mode (JP1)
9. Battery
10. Magnet
11. Magnet fixing screw hole
12. Magnet spacer
LED indicator
In normal operating mode, the LED is off, except for the following situations:
When the tamper switch of the device is opened
When the battery of the device is flat
When the device is in Test mode
The LED does not flash if the tamper switch and the battery of the device are working normally and not in Test mode.
The LED flashes to indicate that a signal is being transmitted and flashes rapidly twice when it receives a recognition signal
from the control unit.
Management of alarms generated by opening of the magnet
The detection of the alarm generated by the opening of the magnet can be enabled or disabled by jumper JP1:
If the jumper is ON (the jumper is inserted on the two pins), detection is deactivated and the shock/vibration alarm
remain enabled
.
If the jumper is OFF (jumper removed or "arranged" on a pin), detection is enabled
(
default setting
)
.
Important note:
insert the jumper on JP1 in case you are using the device as inertial sensor only.
