Elko RF Touch, Руководство по установке

Страница: 22 / 48

22
RFSTI-11B
RFTC-10/G
RFSTI-11G IN
RFTI-10B EXT
RFSTI-11/G KOMBI
RFTI-10B IN
3 2 1 4
7 6 5 8
A 0 9 B
E D C F
C OK
RFTI-10B EXT
RFTI-10B EXT
Setting / Programming / Temperature regulation /
Assing new
In the required section (Temperature regulation) select Assign new
(fig. 30) . A list of selected sections actuators will be shown (fig. 31) .
Select the name of the actuator which you want to associate with
the RF Touch. Enter the address of actuator you want to assign −
fig. 32 as indicated on the actuator (see page 11). Confi rm with
OK
.
From the menu you created, select the name to which the actuator
will be assigned (fig. 33) . Confi rm selection − fig. 34 .
The menu is displayed
(fig. 35)
:
• Remove (fig. 40)
− serves to cancel the link between the temperature unit and
thename from the menu Temperature regulation.
• Change of Address (fig. 41)
− editing / change addresses of assigned actuators.
•
Communication test
(fig. 42)
− is used to detect and display the current status of the RF signal
between the RF Touch and programmed actuator.
− press Start to initiate the test, the current status of the signal is
displayed in percentage.
Note: When testing communications the actuator must be connected
with the installation. Communication test can not be performed with
the components powered by batteries (RFTI-10B, RFTC-10/G, RFATV-1,
RFWB-10/T).
• Pair with... (fig. 43)
− Serves to combine the temperature unit with the multifunction
actuator (or RFDAC-71B), where the temperature unit measures
the current temperature and the multifunction actuator
switches on the Temperature regulation based on the measured
temperature. The multifunction actuator switches based on the
fig. 32
fig. 33 fig. 34
fig. 30 fig. 31
fig. 35
room heater
Location
room 1 heater
room heating
bedroom heating
kitchen heating
room 2 heater
room heater
room 1 heater
room heating
bedroom heating
kitchen heating
room 2 heater
Location
Communication test
Remove
Paired with ...
Pair with ...
Change of Address
Temperature regulation
Assigned
receivers
Assing
new
Assign new
Insert address
room heater
room 1 heater
room heating
bedroom heating
kitchen heating
room 2 heater
Location