35
34
W W W. I N E L S . C O M / K I T S
U S E R ´S M A N U A L 2 . 0
NOTIFICATION AND THEIR SOLUTIONS
Upozornění
Postup
Notifi cation
Procedure
Switch-ON date may not be the same as the
switch-OFF date.
All 5 programs are already occupied.
Switch-ON date may not exceed the switch-
-OFF date.
New settings required.
No other program can be entered.
New settings required.
New settings required.
No unit assigned to the room.
Display incomplete - control impossible.
EPROM memory error!
This group is already assigned.
Setting of program for midnight and over
midnight - at the time of 00:00 there is not
any action of the actuator.
AT45 circuit error!
Please contact the manufacturer.
Please contact the manufacturer.
Calibrate the device (unplug the power supply from
device, after reconnecting hold the logo of RF Touch,
calibration will be completed by double tapping the
cross buttons, which appear sequentially in each
corner of the screen).
Setting of time over midnight: set the required
switch-ON time and set the required switch-OFF
time on 00:00, next day set the switch-ON time on
00:00 and set the required „switch OFF“ time.
Setting of time for midnight: set the required switch-ON
time and set the required switch-OFF time on 23:59.
Please contact the manufacturer.
Forgot your password?
Please contact the manufacturer for further infor-
mation.
Impossible to control display.
Forced calibration is performed when restarting RF
Touch and then hold your finger on (screen) RF Touch
logo.
NOTIFICATION AND THEIR SOLUTIONS
RF TOUCH UNIT NOTIFICATIONS
Notification is displayed in case of incomplete, inaccurate or incorrect entry information.
Notifi cation
Saving failed.
Delete failed.
Up to 40 rooms may be defined.
Two time programmes overlap within a
single day.
No unit assigned.
Repeat entry.
Repeat entry.
No more than 40 device names may be entered.
New settings required.
No other programme can be entered.
Assign the requested unit.
Procedure
No time programme available within a
single day.
Switch-ON time may not exceed the
switch-OFF time.
Unit already assigned to the room.
Select another room.
No day selected.
The address has already been selected in the
unit list. Choose another address.
This room has already been defined in the
group.
New settings required.
One actuator can be assigned to one device name
(except for Quick Control)
New settings required.
Enter correct information.
Enter correct information.
Enter a new name.
The address information must be complete.
„xxx“ - displayed instead of temperature.
Actuator not programmed, actuator/sensor defect,
communication failure.