21
20
W W W. I N E L S . C O M / K I T S
U S E R ´S M A N U A L 2 . 0
ADDITIONAL SETTINGS
Change password
8.
Change Password (PROG.)
: used to change a password which allows you to go to a programming
mode. By entering a password - Fig. 5 (default password 1111), the screen to enter a new password will
appear - where you type and confirm a new password. Press
OK
to save the new password (Fig. 6).
Reset the device:
To reset a device use the password 1234 (Fig. 7). This password cannot be changed.
By inserting a password and confirmation YES (Fig. 8) you will restore the unit to its factory settings.
Fig.
6
Fi
6
Fig.
6
Fig.
7
Fi
7
Fig.
7
Fig.
8
Fi
8
Fig.
8
Fig.
4
Fi
4
Fig.
4
Fig.
5
Fi
5
Fig.
5
Fig.
3
Fi
3
Fig.
3
ADDITIONAL SETTINGS
Fig. 3
Fi
3
Fig. 3
Fig. 1
Fi
1
Fig. 1
Fig. 2
Fi
2
Fig. 2
Indication of a low-battery condition of Wireless thermovalve
6.
Low battery indicator of Wireless thermovalve appears on the screen (Fig.1). Press the battery to
display the unit name. Use arrow keys
to switch between the name and the address of the unit
(Fig. 2-3). More about the address location can be found on the page 10.
Fig. 1
Fi
1
Fig. 1
Fig.
2
Fi
2
Fig.
2
The display
7.
Background:
select the type of screen background color (black, blue, green, purple).
Screensaver:
the desired brightness (25%, 50%, 75%, 100%) will be activated after a set amount of
time after the last touch is detected (15s, 30s, 1min, 3min).
Sleep mode:
set the time after which RF Touch screen unit goes to sleep after last touch - the screen goes
dark (0min, 10min, 15min, 20min)
Calibrating the display:
the cross buttons appear in every corner of the screen, required to tap twice.
Calibration will be performed. Display calibration can also be started by resetting the unit or disconne-
cting the power supply from the unit; after reconnecting again, the RF Touch logo will appear on the
display - hold the logo for more than 3s to activate calibration – touch logo longer than 3 seconds and
calibration will be activated.
Heating 1