WARNING: Please carefully read and properly follow the instructions for installation found in this manual.
STEPS:
4
3/16 in. to 3/8 in.
Wall
1
1
1
5
in. Min.
2
5
4
Before installation, select the location for the filtration manifold (5). The screws should be
placed a minimum of 15 in. above the bottom of the floor where the filtration system is to be
mounted. Any distance lower
than 15 in.
may result in the filter set (6) interfering with the floor
when removing the filters for maintenance.
Use the filtration manifold (5) as a template to mark the screw hole locations where the
screws are to be installed.
Installing into drywall: Drill two 1/4 in. holes and insert the anchors (3) and screws (4).
Installing into wood: Drill two 1/8 in. holes and insert the screws (4). Do not use anchors (3).
Install screws into the wall, leaving 3/16 in. to 3/8 in. clearance between the head of the screw
and wall. Hang the filtration manifold (5) on screws (4)
and tighten
until the filtration manifold (5) is
held firmly.
4
3
6
(
+
)
(
-
)
2
2
5
1
3
6
O
pen the timer cover (4).Install two AA batteries (5)
(not included)
by matching the positive (+) and Negative (-) ends
on the battery (5) to the (+) and (-) markings in the timer (6). The negative ends of the battery (5) should always
connect to the spring end of the battery slots in the timer (6). Reinstall the timer cover (4) by covering into place.
NOTE: Use only AA Alkaline batteries. Identify the Anode (+) and the Cathode (-) to install the batteries properly. To
avoid battery damage: Do not recharge or disassemble batteries; Do not mix old batteries with new batteries; Do not
use carbon batteries; Do not expose batteries to extreme heat. Do not mix alkaline, standard (carbon-zinc), or
rechargeable (ni-cad, ni-mh, etc) batteries.
6
6
4
4
6
