WARNING: Please carefully read and properly follow the instructions for installation found in this manual.
STEPS:
2
Green
6
C
1
1
2
Connect the end of the hose (7) with the quick connector to the tee connector (6).
Push the quick connector
with the green tab on the hose (7) firmly upward and attach it
to the receiving block with green on the tee connector (6). Pull moderately to ensure the
connection has been made. If it is necessary to remove the quick connector, squeeze
the tabs on the quick connector and then pull to disconnect.
Connect the other end (3) with inlet indicated by the tag of the hose (7) into the end (4)
with inlet indicated of the filtration manifold (8). Pull moderately to ensure the connection
has been made.
Install the filter set (9) onto the filtration manifold (8). After the thread of the filter set (9) is
completely
screwed into the filtration manifold (8), it cannot be rotated manually.
After connection is completed, turn on the cold water supply valve to flush the water line
for ten minutes. This flushes out any harmless carbon fibers that may be present. Check for
leaks. Place a bucket
to
catch the water during this flush around the end (5) with outlet
indicated of the filtration manifold (8) and make sure the water does not overflow from the
bucke
t
.
Turn off the cold water supply valve.
6
7
7
7
8
9
3
4
5
C
H
Connect the end (1) with outlet indicated by the tag of the outlet hose into the end (2) with
outlet indicated of the filtration manifold (3). Pull moderately to ensure the connection has
been made.
1
2
3
